2 L-Brackets
4 3/8"Stainless Steel 1/4-20 bolts
4 Starlock Washers
2 Double T-Nuts
4 3/8" Stainless Steel 1/4-20 bolts
4 Starlock Washers
4 Roll-In T-Nuts
2 1" Black with Patch Bolt
CampKitchen / Icebox .x1 Extrusion Frame Modification Kit
Hardware Kit
Hardware
Installation Steps
Step 1:
Taking a L-Bracket lossen two (2) 3/8" Stainless Steel 1/4-20 bolt enough for the Double T-Nut to slide into the short piece of Extruision. Then loosley tighten into place. Repeat on other side.
See Image for Reference
Step 2:
Once both L-Brackets are loosely secured into place. Align the Extrusion bars onto the back of the CampKitchen 2.3 or IceBox 1.3 with a pencil mark all four (4) holes of the L-Bracket.
Step 3:
Insert Roll-In T-Nuts into the four (4) marked, two (2) on each side. Once the T-Nuts on in place, align the Extrusion Extension back onto the CampKitchen or IceBox. Using a 3/8" Stainless Steel 1/4-20 bolt and Starlock Washers loosely secure into place. Once all bolts are in place, hand tighten all eight bolts securing the L-Bracket into place.
Step 5:
With help place the Module on its side revealing the bottom of the CampKitchen or IceBox. Using two (2) 1" Black with Patch Bolt insert bolt into corner block into the Extrusion Extention securing it into place.
Step 6:
Once both 1" Black with Patch Bolts are secured into place your CampKitchen or IceBox is ready to re-install into your vehicle and install the Seat Delete Plate System - Module Height Platform.